Harman Stove Company HARMAN P68 - Manual (Page 26)

26 P68 Pellet Stove
The glass in your Harman stove is a special 5mm
ceramic glass.
• Do not abuse the glass by striking or slamming
the door.
• Never burn the appliance if the door glass is
cracked or broken.
• Replace only with Harman supplied glass. Do
NOT Use Substitutes.
Soot and/or fly-ash may accumulate on the viewing
glass, and will ocassionally need to be cleaned. Clean
the glass with a soft cloth and mild glass cleaner. Do
not clean the glass when hot, and avoid the use of
abrasive cleaners.
Glass replacement
Carefully remove all remaining glass and gasket
materials prior to replacing the glass.
Lay the door face down on a flat surface. Remove the
glass retainers and screws. Apply the gasket material
to the face of the new glass. Lay the glass into the
door, making sure that the glass is contained within
the channels and raised areas of the door itself. Lay
the glass retainers into position and install the screws. Tighten each screw evenly to avoid making any stress points.
Retainers and screws
Glass
Adhesive gasket
Door Frame
3-90-00688R24_06/13
Maintenance
Pellet fines may accumulate in the feeder body over a period
of time; therefore, a yearly inspection and cleaning of this
must be performed.
To clean out fines:
1. Remove right rear cover panel.
2. Remove wing nuts and feeder cover on the right
side of the feeder.
3. Use a vacuum cleaner to remove all fines.
4. Reinstall feed cover, wing nuts, and right rear
cover panel.
Pellet Fines may build
up in this area
5/16" Hex Head
Screws (2 on
each side)
5/16" Hex Head
Screws (2 on
each side)