Humminbird 967C - Manual (Page 18)

10. While holding cables in place in
the cable collector insert, thread the
cables through the slot in the bottom
of the cable collector cover, line up
the cable collector insert and cover,
then slide the cover into place on the
insert.
NOTE: The tab on the Cable Collector
insert goes into the slot on the cover.
10. Attach the cable collector insert to the cable collector cover using
the 2 Phillips screws provided.
11. Place the control head back onto the mounting bracket. Plug in the
cable collector assembly to the back of the control head. Cable
connectors and cable sockets are keyed to prevent reverse
installation, so be careful not to force the connectors into the wrong
sockets. Once the cable collector and all cables are plugged into the
back of the control head, lock the assembly into place by threading
the knurled screw into the threaded insert on the back of the
housing. Adjust the control head to the desired viewing angle and
secure by tightening the gimbal knobs.
NOTE: You may wish to dress the cabling with nylon wire ties in order to hold the
cables together and create a cleaner assembly.
The Humminbird® 900 Series™ control head is now ready for operation.
Plug Cable Connector Assembly to
Back of Control Head
Cable Collector Insert 1
Screws 2
Cable Collector Cover 3
Tab on Insert 4
Slot on Cover 5
1
2
3
4
5
Power 1
Temp/Speed 2
Communications 3
Transducer 4
Cable Collector Insert 5
1 2 3 4
5
10