Humminbird 967C - Manual (Page 115)

To Select Readouts:
1. Make sure you are in Advanced User Mode, then highlight Select
Readouts on the Setup main menu.
2. Use the RIGHT 4-WAY Cursor Control key to initiate this procedure.
3. The Select Readouts submenu will appear, showing a list of all
Readouts. Use the UP or DOWN Cursor keys to select a particular
Readout position, then use the RIGHT or LEFT Cursor keys to change
what will be displayed at that position. (Aux. Temperature, Course,
Depth, Off, Position, Speed, Temperature, Time, Time+Date, Triplog,
Voltage, Water Speed)
Depth Offset
(Advanced)
Depth Offset will adjust the digital depth readout to indicate depth from the
waterline or boats keel. Enter a positive vertical measurement from the
transducer to the waterline to read the depth from the waterline. Enter a
negative vertical measurement from the transducer to keel to read the depth
from the keel. This menu choice is available only when in Advanced User
Mode (see Setup Menu Tab: User Mode.)
To change the Depth Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Depth
Offset on the Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change
the Depth Offset setting. (-10.0 to +10.0 feet or -3 to 3 meters
[International models only], Default = 0.0, or Off)
Aux. Temp. Offset
(Advanced)
Aux. Temp. Offset will adjust the aux. temperature readout (the temperature
on the optional-purchase temperature probe or Temp/Speed accessory) by
the amount entered. This menu choice is available only when in Advanced
User Mode (see Setup Menu Tab: User Mode.)
To change the Aux. Temp. Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Aux.
Temp. Offset on the Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the
Aux. Temp. Offset setting. (-10.0 to +10.0 degrees, Default = 0)
Temp. Offset
(Advanced)
Temp. Offset will adjust the temperature readout by the amount entered.
This menu choice is available only when in Advanced User Mode (see Setup
Menu Tab: User Mode.)
To change the Temp. Offset setting:
1. Make sure you are in Advanced User Mode, then highlight Temp.
Offset on the Setup menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the
Temp. Offset setting. (-10.0 to +10.0 degrees, Default = 0.0, or Off)
107