Humminbird 967C User Manual

Page 105

Set Simulation Position

(Advanced)

Set Simulation Position allows you to set the position of the boat used in
the Simulator.

To set the Simulation Position:

1. Activate the cursor and move it to the coordinates from where you

want simulation to start.

NOTE: The cursor must be active in order for this procedure to work.

2. Make sure you are in Advanced User Mode, then highlight Set

Simulation Position on the Navigation main menu.

3. Use the RIGHT 4-WAY Cursor Control key to change the Simulation

Position setting. A confirmation dialog box will appear to allow you
to change your mind, or to confirm your choice. If the cursor was not
active before you began this procedure, you will see an error
message. Exit the menu, set the cursor, then try again.

Set Map Offset

(Advanced)

Set Map Offset allows you to change the map offset used by the 900 Series™.

NOTE: The Map Offset will be applied to all maps and not just the map that
requires the correction. The Map Offset should be cleared if a different map is to
be used.

To change the Map Offset setting:

1. Activate the cursor and move it location where the Map Offset will

be applied.

NOTE: The cursor must be active in order for this procedure to work.

2. Make sure you are in Advanced User Mode, then highlight Set Map

Offset on the Navigation main menu.

3. Use the RIGHT 4-WAY Cursor Control key to set the Map Offset.

A confirmation dialog box will appear to allow you to change your
mind, or to confirm your choice. If the cursor was not active before
you began this procedure, you will see an error message. Exit the
menu, set the cursor, then try again.