Hitachi VM-E220A - Manual (Page 29)

Advanced Techniques - 29 -
manually.
2. Use the power zoom T control to zoom up completely to your subject. If you don't use the T control to zoom to
the picture you want, the picture may fall out of focus when actual recording starts.
3. Press the Focus control F (far) or N (near) button until the subject is in focus.
4. Use the power zoom W control to zoom back to the picture you desire.
Note: To return to auto focus press the FOCUS control buttons and the FOCUS disappears from the
viewfinder.
Using Instant Review
Use this feature to view the last few seconds of the tape you shot.
1. Set the camcorder to record/pause mode and tap the REW button. The last few seconds of tape play back in
reverse and then in normal playback mode.
2. The camera plays back to the spot where you paused and returns to record/pause mode (standby). Press the
Start/Stop button to resume recording.
Using Quick Edit
Use quick edit to search for the end of previously recorded material, find a particular spot on your tape, begin
editing, or record new material. While the camera is in record/pause mode hold down the F.F, REW, or PLAY
button and visually search the tape. Release the button and the camcorder stops the tape at the exact position
you selected.
Using Macro
This function allows you to shoot subjects as close as 3/8 inches (1cm). Press and hold the power zoom control
W. The camera focuses on the subject automatically. Check your lighting as it tends to be insufficient when
filming close up.