Configuring the autodesk control surface on linux – HP XW8400 User Manual

Page 30

Connecting System Components

Select the Use the following IP address option.

Set a static IP and Subnet mask address for the port. Select values that do not conflict with
any other machine on your network. Consider using the following values:

•

IP address: 192.168.125.10

•

Subnet mask: 255.255.255.0

Click OK twice.

To configure the Autodesk control surface on Linux-based workstations:

On the Lustre workstation, use a text editor such as nedit to configure the network port
connected to the control surface with an unrelated static IP address that does not interfere
with any of the IP addresses on the network. Also assign an appropriate subnet mask. Type:

nedit /etc/sysconfig/network-scripts/ifcfg-eth

Modify the IPADDR and NETMASK values. For example:

IPADDR=192.168.125.10

NETMASK=255.255.255.0

ARNING

The last digits of the IP address must not conflict with the panel IDs included in the

lustre.config file.