Related documentation – HP XW8400 User Manual
Page 10
Introduction
1
6
For workflow information related to the HP xw8400 running on Linux for Incinerator, refer to
the Autodesk Incinerator Installation and User’s Guide.
To install Lustre on an HP xw8400 workstation:
1.
Review the guidelines for working with hardware components. See
2.
Connect all peripherals (mouse, keyboard, graphics monitor, storage, etc.) to each
workstation in your workgroup, and connect each workstation to the network. See
3.
Connect your workstation to Autodesk Stone® Direct storage. See the Stone Direct
Configuration Guide.
4.
Connect your Master or HD Station to a Slave Renderer, a control surface, tablet, and video
I/O components. See
Chapter 3, “Connecting System Components,”
N
OTE
:
The Slave Renderer is not used in Incinerator configurations.
5.
Perform the procedures in the Autodesk Lustre 2007 Software Installation Guide or the
Autodesk Incinerator 2007 Installation and User’s Guide to install and license Lustre and
Incinerator.
Related Documentation
The following table describes the documentation associated with your application. For a
detailed list of the latest documentation, see your release notes.
User Guides
Provides
Autodesk Lustre 2007 User’s Guide
Detailed instructions on using the software.
Autodesk Control Surface User’s Guide
Detailed instructions on using the Autodesk
control surface and the Tangent CP100.
Autodesk Lustre 2007 What’s New
A list of the new features for this release.
Autodesk Lustre 2007 Hot Keys Card
A list of the most frequently used hot keys.
Autodesk Lustre (and Incinerator) Release
Notes
(for this release)
A complete list of documentation and information
on late-breaking features.
Autodesk Lustre (and Incinerator) Fixed
and Known Bug List
(for this release)
A complete list of fixed and known bugs for this
release.