HP Vectra 500 Series - Manual (Page 88)

88
4 Summary of the HP/Phoenix BIOS
HP/Phoenix BIOS (BIOS version: GX.07.xx)
be locked , so as to prevent the exporting of data. Writes to the hard disk
drive boot sector can also be locked , for instance as a protection against
viruses.
Under the “Start-Up Center” sub-menu, the Setup program not only allows
the user to select which devices are to be used (
yes or no ) for booting up
the system, but also indicates their order of precedence when more than one
is enabled: flexible disk drive, CD-ROM drive, or hard disk drive.
Power Menu (BIOS version: GX.07.xx)
The “Power” menu allows the user to set the standby delay. It also allows the
system administrator to decide whether the mouse is enabled as a means of
reactivating the system from Standby. It is also possible to specify whether
the space-bar is enabled as a means of reactivating the system from Off.
Summary Configuration Screen (BIOS version: GX.07.xx)
You can press while the initial “Vectra” logo screen is being displayed to
run the Setup program (as described in the previous sub-sections).
Alternatively, you can press
to view the summary configuration screen,
an example of which is depicted on the next page. By default, this remains
on the screen for 20 seconds, but by pressing
once, it can be held on the
screen until is pressed again, or until is pressed. Pressing will
cause the PC to be turned off.