Table of contents introduction, Serial #: = contains updated information, Usa canada floor protector – Harman Stove Company Harman Pellet P43 User Manual
Page 4: 9"(228mm)
![background image](/manuals/95800/4/background.png)
4
P43 Pellet Stove
3-90-04301R18_03/13
Safety Information
5
Installation
6
Venting 8
ESP Control
15
Automatic
Operation 16
Manual
Operation
19
Low Draft Voltage Adjustment
21
Maintenance
22
Troubleshooting
27
Specifications / Wiring Diagram
28
Options 29
Fuel Specification Details
30
Power Failure / Back-up
32
Warranty
33
Service
Parts
35
Division of Hearth & Home Technologies, Inc
352 Mountain House Road
Halifax, PA 17032
table of contents
introduction
The P43 Pellet Stove has huge features in a small package, giving you 0 to 43,000 BTU when you need it,
automatically. You basically need to set your desired room temperature and fill the hopper. With the P43 you will
notice even heat throughout your zone and a level of convenience you never thought possible.
The P43 epitomizes the capability of Harman Pellet Stoves, taking advantage of Harman’s 20+ years of pellet
stove design, technology and manufacturing. This 43,000 BTU stove has the smartest controls coupled with
minimal maintenance. The P43's output is managed by a microprocessor that senses the room temperature and
the fire temperature with tiny thermistor probes and then determines the best feed rate for your heating demand.
This improved and smarter control also has a diagnostic port which allows a service representative to attach an
external display showing live working data for ease in troubleshooting.
The platinum combination is Harman’s Patented Feeder & Burn Pot, and ESP Control which have been developed
to their highest state. These features work together to allow amazing heat output with little regard for fuel quality.
Safety listing: Omni-test laboratories, inc.
tested to: ASTM E1509-04, ULC S627-00, and
ULC/ORD-C1482-M1990. Report #135-S-23b-6.2
This appliance is also approved for installation into a
shop.
"PREVENT HOUSE FIRES"
Install and Use Only in Accordance With Manufacturer's Installation and Operation Instructions.
Contact Local Building or Fire Offi cials About Restrictions and Installation Inspection in Your Area.
WARNING : THE STRUCTURAL INTEGRITY OF THE MANUFACTURED HOME FLOOR, WALL,
AND CEILING/ROOF MUST BE MAINTAINED. DO NOT INSTALL IN SLEEPING ROOM.
An outside combustion air inlet must be provided. Refer to Manufacturer’s instructions and local
codes regarding the requirements for passing the exhaust venting system through a combustible
wall or ceiling.
Inspect and Clean Exhaust Venting System Frequently.
Use a 3" or 4" diameter type "L" or "PL" venting system.
Do Not Connect This Unit to a Chimney Flue Serving Another Appliance.
FOR USE WITH WOOD PELLET FUEL OR UP TO 50% CORN / PELLET MIXTURE ONLY.
The Use of Other Fuels May Create an Unsafe Condition.
Input Rating Max: 5.5 lb. fuel/hr.
U.S. Electrical Rating: 115 VAC, 60 Hz, Start 4.2 AMPS, Run 2.8 AMPS
Route Power Cord Away From Unit.
DANGER: Risk of Electrical Shock. Disconnect Power Before Servicing Unit.
For Further Instruction, Refer To Owner's Manual.
Replace glass only with 5mm ceramic available from your dealer.
Keep Viewing and Ash Removal Doors Tightly Closed During Operation.
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
MINIMUM CLEARANCES TO COMBUSTIBLES/
DISTANCES DE SECURITE PAR RAPPORT AUX
MATERIAUX COMBUSTIBLES:
Back Wall / Entre Mur Arrière 2”/ 51mm
2”/ 51mm
Side Wall / Entre Paroi Latér
16”/ 406mm
10”/ 254mm
CORNER INSTALLATION / EN ANGLE
Walls to Appliance
9”/228mm
9”/228mm
Entre Murs et appareil
Flue Connector/Raccord à la cheminée 3” /76mm
FLOOR PROTECTION / Protection Du Plancher
USA Canada
Sides*/Côtés (A) 6”
200mm
Back**/Arrière (B) 6”
200mm
Front*/Avant (C) 6”
450mm
**Measured from pedestal base in the US ONLY
**Mesuré à partir de la base du socle aux États-Unis uniquement
*Measured from Glass Opening
*Mesurer à partir de la surface de la porte en verre
Floor Protection Must Be a Non-Combustible Material.
Must Also be Place Under Any Horizontal Flue Connector,
Extending 2” or 51mm Beyond the Pipe Measurement.
Pour protéger le plancher, il faut sous le pêole un matériau. Qui
doit aussi être placé sous les parties horizontales du tuyau de
raccord à la cheminée et s’étendre à 51mm o 2 po. au-delà de
la mesure du tuyau.
Made in U.S.A. of US and imported parts. / Fabriqué
aux États-Unis-d’Amérique par des pièces d’origine
américaine et pièces importées.
"PREVENTION DES INCENDIES"
Respecter scrupuleusement les instructions du constructeur pour l'installation et les consignes
de fonctionnement. Respecter les règles de sécuritè en vigueur dans votre région.
AVERTISSEMENT POUR MOBILE HOMES: Ne pas installer dans une chambre. ll est imperatif
de prévoir une prise d'alr extérieur. L'intégrité structurale du plancher, du plafond et des murs doit étre
strictement préservée. Se reporter aux instructions du fabricant et aux réglementations spécifi ques
locales concernant les précautions requises lors de la traversée d'un mur ou d'un plafond.
Contróler et nettoyer fréquemment tout le systeme d'evacuation des fumées conformément aux
recommandations du constructeur. Utiliser des tuyaux <
102 mm. Ne pas raccorder ce poéle à un conduit de cheminée déjà utilisé pour un autre appareil.
FONCTIONNE EXCLUSIVEMENT AVEC DES GRANULES DE BOIS.
Appareil de chauffage à granulé type. Consommation maximum: 2.5 kg/h.
US coupure: 115 VAC, 60 Hz, 4.2 amps Démarrer, Exécuter 2.8 AMPS
fonctionnement normal 1.1A. Tenir le cordon d'alimentation à l'écart du poèle.
DANGER: Risque d'électrocution. Débrancher l'appareil avant toute intervention.
Ne remplacer la vitre qu'avec une vitre céramique 5mm de méme qualité disponible
auprès de votre revendeur.
Pour une information plus compléte, se reporter à la notice d'utilisation. Tenir la porte
hermétiquement close durant fonctionnement.
Ne faites pas obstacle l’espace sous le réchauffeur. Toujours fournir un approvisionnement suffi sant en air frais
jusqu’au lieu d’installation Appliance
BARCODE LABEL
Date of Manufacture / Date de fabrication:
P.N. 3-90-04300
WITHOUT
SIDE SHIELDS
WITH
SIDE SHIELDS
Sans Écrans
Latéraux
Avec Écrans
Latéraux
Fabriqué par: Harman Stove Company 352 Mountain House Road, Halifax PA 17032
US ENVIRONMENTAL PROTECTION AGENCY
This model is exempt from EPA certifi cation under 40 CFR 60.531
by defi nition [Wood Heater (A) "Air-to-Fuel Ratio"]
Agence Américaine pour la Protection de l’Environnement
Ce modéle est dispensé par EPA certifi cation d’aprés 40 CFR 60.531
par dèfi nition [Appareil á bois (A) << Ratio air/combustible>>]
2012 2013 2014 jan Feb MaR aPR MaY jun jul aug SeP Oct nOv dec
Harman PP38+/P43 Pellet Stove
Label measures: 4-3/8" high X 10-3/4"wide
Black Background with bare metal for print-adhesive backed, metal plate.
008
Serial No.
N
o
de série:
Report #/ Raport # 135-S-21-6.2 (PP38+)
Report #/ Raport # 135-S-23b-6.2 (P43)
Tested to / Testé à:
ASTM E1509-04, ULC/ORD-C1482-
M1990, ULC-S627-00
Room Heater Pellet Fuel Burning Type. Also for use in Mobile Homes.
Appareil de chauffage à granulés de bois Utilisable dans des mobile homes.
This pellet burning appliance has been tested and listed for use in Manufactured
Homes in accordance with OAR 814-23-900 through 814-23-909
MODEL / MODÈLE: "PP38+ / P43"
2"(51mm)
10" (254mm) with side shields
16" (406mm) w/out side shields
a
a
c
b
uSa
canada
Floor protector
PROtectiOn de SOl
FlOOR PROtectiOn
9"(228mm)
9"(228mm)
3" min
76mm min
3" min
76mm min
Rev c
This label is located on the back of the unit.
Please copy the Serial Number for future reference.
Serial #:
= contains updated information