Hitachi C 10RA3 - Manual (Page 3)

– 3 –
English
WARNING
Some dust created by power sanding, sawing, grinding, drilling and other construction activities contains
chemicals (known to the State of California) to cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• Lead based paints
• Crystalline silica from bricks, cement and other masonry products
• Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your
exposure to these chemicals, work in a well-ventilated area and work with approved safety equipment, such
as dust masks that are specially designed to fi lter out microscopic particles.
PRODUCT SPECIFICATIONS
MOTOR SAW
HP (Maximum developed) ......................... 3.5 Table Size with Extensions .......... 30-3/4” x 19-1/2”
Type .......................................................... Universal Table Extension ........................... Right
Amps ......................................................... 15 Rip Capacity with Extension ......... 24-1/2”
Voltage ...................................................... 120 Blade Size .................................... 10”
Hz .............................................................. 60 Rip Scale ...................................... YES
RPM (no load) ........................................... 5000 Rip Fence ..................................... YES
Overload Protection ................................... YES Miter Gauge ................................. YES
Maximum Cut Depth @ 90º .......... 3”
Maximum Cut Depth @ 45º .......... 2-1/2”
Maximum Dado Cut Width ........... 1/2”
Net Weight ................................... 58.3 LBS
WARNING
To avoid electrical hazards, fi re hazards or damage to the table saw, use proper circuit protection.
This table saw is wired at the factory for 110-120 Volt operation. It must be connected to a 110-120 Volt /
15 Ampere time delay fuse or circuit breaker. To avoid shock or fi re, replace power cord immediately if it is
worn, cut or damaged in any way.
Before using your table saw, it is critical that you read and understand these safety rules. Failure to follow
these rules could result in serious injury to you or damage to the table saw.