Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1 - Manual (Page 2)

SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Remove partial OEM cup-holder/console located on the transmission hump.
Note: Do not remove metal housing attached to this partial console. This piece is meant to strengthen the
vehicles crumple zone and must not be removed.
INSTALLATION:
View of partial OEM
console removed
Attach rear extrusion bracket
(CM001380) to vehicle using
factory screws from, “partial
console,” removal.
Sub-assemble C-B43 (only the
piece shown), 18” portion of
trak, extrusion adapter bracket,
rear extension bracket and 12”
portion of trak
Attach C-B43 transmission
hump bracket to 18” section
of extrusion using (4) ¼” x
¾” bolts and serrated nuts.
(7/16” Wrench)
Attach extrusion adapter
bracket to 18” section of
extrusion using (2) ¼” x
¾” bolts and serrated nuts.
(7/16” Wrench)
Attach the extrusion adapter
bracket to the 12” section of
extrusion using (2) ¼” x ¾”
bolts and serrated nuts.
(7/16” Wrench)
C-TM-IMP-1_INST_11-08 2