Havis-Shields 2006-2007 Dodge Charger and Magnum C-VS-2400-CHGR - Manual

INSTALL INSTRUCTIONS
C-VS-2400-CHGR & C-VS-2400-CHGR-1
2006 – 2007 DODGE CHARGER and MAGNUM
2008 DODGE CHARGER and MAGNUM
TOOLS REQUIRED:
Ratcheting wrench
Sockets - 7/16”, 10mm, 8mm
Screwdriver set
T-20 Torx bit
HARDWARE:
ITEM QTY DESCRIPTION PART#
1 1 Console housing assembly C-VS-2400-CHGR-H
2 1 Front support bracket CM001593
3 2 Side trim panels - 2006 – 2007 Charger CM001598-D and P
3 2 Side trim panels - 2008 Charger CM002164 and CM002165
4 1 Front floor bracket CM001595
5 1 Sensor guard CM001638
6 1 Rear floor panel CM001642
7 6 #10 x ½” machine screws GSM33118
8 2 #10 keps nuts GSM30028
9 4 #10 flat washers GSM31003
10 4 ¼” flat washer GSM31005
11 4 ¼” x ½” carriage bolt GSM31999
12 4 ¼” Nylock nut GSM30016
2 ¼” x ¾” self threading bolt GSM33060-1
2 ¼” x 1” fender washer GSM31014
2 6mm hex nut GSM30201
1 1-1/16” diameter plug GSM20017-1
1 Hardware Kit C-HK
1 Torx Hardware Kit C-HK-1
10, 11, 12 7, 9
7, 9
1
6
5 - Not shown, approximate location
4
3
2