Havis-Shields Heavy Duty Trak Mount 2006-2009 Chevrolet Impala C-TM-IMP-1 - Manual

INSTALL INSTRUCTIONS C-TM-IMP-1
HEAVY DUTY TRAK MOUNT
2006-2009 CHEVROLET IMPALA
TOOLS REQUIRED:
Ratcheting wrench
Standard Socket set
Open-end wrench set
Screwdriver Set
HARDWARE:
QTY DESCRIPTION
PART #
1 18” Length Extrusion CM93055-2
1 12” Length Extrusion CM93055-1
1 Transmission Hump Bracket (no holes drilled) C-B43
1 Rear Extrusion Bracket CM001380
1 Extrusion Adapter Bracket CM001379
12 ¼” Serrated Nut GSM30023
C-B42
12 ¼ x ¾” Hex Head Bolt GSM33001
6 ¼” x ¾” Phillips pan head machine screws GSM33124
6 ¼” Flat washers GSM31000
2 #10 x ¾” Phillips pan head machine screws GSM33119
6 ¼” x ¾” Hex Head Lag Bolts GSM33060-1
Always
!
¾ Read all instructions before installing any Havis-Shields Equipment Corp products.
¾ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾ Use hardware provided with install kit
¾ For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html , email [email protected] or call
1-800-524-9900.
Transmission
Hump Bracket
(C-B43)
Rear Extrusion
Bracket
Extrusion
Adapter Bracket
18” Length
C-TM-IMP-1
Extrusion
12” Length
Extrusion
Under seat
Guide bracket
adapter bracket