beautypg.com

Havis-Shields Computer Laptop Mount and Accessories C-3090's User Manual

Computer laptop mount and accessories

background image

INSTALLATION INSTRUCTIONS C-3090’s & C-3089’s

COMPUTER LAPTOP MOUNT AND ACCESSORIES

TOOLS NEEDED:
Ratcheting wrench
Standard socket set
Open-end wrench set

Allen wrench set
Screwdriver set

Always!

Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit
For product support, visit the Install Instructions Section of our website at

http://havis.com/Installation/Installation.html

1. MOUNTING C-3090-3 or 4 & C-3089-3 or 4 to C-TCB’S

Photo #3 on page #2 is a basic assembly

instruction of a C-3090-3 (w/ tilt/swivel)
mounting to a C-TCB-x.

• The tilt/swivel assembly, (Photo #1), which

comes pre-assembled to the C-3090 from the
factory, will bolt directly to the rotating plate,
using the hardware loosely attached to the
plate. You do not need to unassembled the
tilt/swivel from the C-3090.

Note: Be sure the 2” fender washer is assembled between
the rotating plate and the tilt/swivel assembly.

2. C-3090-1 or 2 & C-3089-1 or 2 MOUNTING TO

VEHICLE TRAK MOUNTS:

• The C-3090 will come pre-assembled with

tilt/swivel attached.

• Mount trak kit into vehicle.
• Place console and C-3090 into desired

position on trak. (Photo #2)

Note: Be sure assembly does not interfere with dash or
console.

• Slide ¼-20 hex nuts into slots on side of trak

in location to mount C-3090.

• Attach C-3090 to trak using ¼-20 x ½” hex

bolts and washers. Tighten in desired area.

Photo #1

Photo #2

This manual is related to the following products: