Havis-Shields 1997-2007 Dodge Dakota Telescoping Computer Base C-TCB-28 - Manual

3
INSTALL INSTRUCTIONS C-TCB-28
1997-2007 DODGE DAKOTA
TELESCOPING COMPUTER BASE
TOOLS REQUIRED:
Ratcheting wrench
3/8” Metric Socket Set
T-20 torx bit
3/8” Standard Socket Set
Combination wrench set
Powered Drill
Drill Bit set
HARDWARE:
QTY DESCRIPTION PART
#
4 ¼” x 1” Hex head lag bolt GSM33060
1 5/16” Flat Washer GSM31006
1 5/16” Nylock Nut GSM30017
1 “Z” Bracket Support CM002001
1 ¼” x ¾” Carriage Bolt GSM32000
1 ¼” Serrated Nut GSM30023
1 Pole Support Assembly CM93071-28W
1 Lateral Support Brace CM93146
1 Inner Telescoping Pole Assembly CM93072-3
Always
!
Disconnect the vehicles’ battery. Removing seat bolts on some vehicles may give the
vehicles computer a false reading leading to warning lights on dash. This requires the
vehicles’ computer to be reset.
Read all instructions before installing any Havis-Shields Equipment Corp products.
Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
Use hardware provided with install kit.
For product support, visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html , email [email protected] or call
1-800-524-9900.