HP 2000C - Manual (Page 22)

Section 1 Printing Basics
Selecting and Using Paper
Basic Steps for Loading All
Types of Media
To load media in the IN tray
1 Adjust the print settings in your software program and
the HP 2000C printer driver to match the paper type,
size, and orientation of the paper you are using. (See the
topic “Change Print Settings” on the
How Do I? tab in
the HP 2000C Toolbox).
2 Slide the paper width adjuster to the left and slide the
paper length adjuster out to make room for the paper,
transparencies, or envelopes.
3 Place a stack (up to 5/8 in. or 16 mm thick) of paper,
transparencies, or envelopes print side down in the
IN tray with the right side of the stack against the right
side of the tray, and push in the stack until it stops.
The OUT tray can be lifted and clicked into a raised position while loading
media. This is especially helpful when loading smaller media. Be sure to
lower the tray before printing.
4 Readjust the paper width and length adjusters to
fit snugly against the stack’s edges without bending
the media.
Basic Steps for Loading All Types of Media
21
ug_guts.qxd 4/2/98 1:01 PM Page 21