Hotpoint DDP-700 - Manual (Page 48)

MODEL NAME
D DP-7 00
USER GUIDE
PAGE
ADVANCE FEATURES
45
FACTORY PRESET -Routable Code:
This is the routable code number and is preset in the factory. When LCR is “on”, your D DP-7 00 will compare the
dialed number to the routable code table, if it match, it will route the call.
1. Press up to select
LCR
menu.
2. Press . Your D DP-7 00 will ask you to enter the PIN Code. (See PIN CODE Setting)
3. Enter the PIN Code. Press .
4. Press to select
ROUTABLE.
4.1 Press to select NEW
4.1.1 Press .
4.1.2 Enter area code, maximum 5 different area codes each maximum of 6 digits.
4.1.3 Press .
4.1.4 Press and Hold to exit LCR programming and return to standby mode, press once
to exit routable code setting or repeat 4.1 to store another code.
4.2 Press to select EDIT
4.2.1 Press .
4.2.2 Search the routable code to be edit using . Press .
4.2.3 Press to delete one character to the left side of the cursor or add character by
pressing the correct number.
4.2.4 Press . A confirmation tone is heard.
4.2.5 Press and Hold to exit LCR programming and return to standby mode, press once
to exit edit routable code or repeat 4.2.
It is highly recommended that you just leave this codes untouched. However, if you add routable codes you can
program them. Factory preset area codes are : 0, 00, 3 and 4.
Routable Code