Hotpoint DDP-700 - Manual (Page 33)

MODEL NAME
DDP-700
USER GUIDE
PAGE
EXPANDING YOUR DECT SYSTEM
Pico cellular system
Your DDP-700 MINI DECT cordless phone can be configure as a pico-cellular system by adding more base placed
in different locations. This will extend your handset mobility. This application can be implemented in the office or
factory. If you configure your DECT system to operate in pico-cellular, you should see to it that the placement of
base unit will be optimized to cover the entire location where you intend to use your
DDP-700 handset.
The following should be observed :
1. Register another base/s (another DDP-700 base or another DECT GAP compatible) to your DDP-700 hand
set.
2. Place these base in the location where you intend to operate your handset, place them to cover all area
without dead spot, this means that each base station is within the range of each other base. Please see
figure below :
30
A
B
C
D
3. Your D DP-700 however cannot establish a seamless handover (handover means the transfer of call-connec
tion from the range of location A to location B, please see figure above). The handover from location A to
be takes about 2 seconds or more. Thus, when you are on call progress on location D and moving to
location C, your
DDP-700 will warn you (if out of range warning is set to on-see warning tone) of out of range
from location D. If you move closer to location C, your DDP-700 handset will lost connection and call will
be cut off. If you move further to location C, your DDP-700 handset will be connected to the base located
at C.