HP DL120 - Manual (Page 86)

Diagnostic tools 86
Error code Error message Corrective action/description
0200 Failure Fixed Disk Fixed disk is not working or was not configured
properly.
1 Run Setup and check if the fixed-disk type is
correctly identified.
2 Check to see if the fixed disk is attached properly.
0210 Stuck key Stuck key on keyboard.
1 Locate the stuck key on your keyboard and release
it.
2 Reboot the server.
0211 Keyboard error Keyboard not working.
Verify that the keyboard cable is securely
connected to the keyboard port (not the mouse
port) on the rear panel of the server.
If the problem persists, replace the keyboard or
contact your HP Customer Support provider.
0212 Keyboard Controller Failed Keyboard controller failed test.
0213 Keyboard locked - Unlock key switch Keyboard error. Replace the keyboard.
0220 Monitor type does not match CMOS -
Run SETUP
The attached monitor cannot be correctly
identified by Setup.
Run Setup and check if the monitor type is
correctly identified.
0230 Shadow RAM Failed at offset: nnnn
0231 System RAM Failed at offset: nnnn
0232 Extended RAM Failed at offset: nnnn
One or more defective memory module.
1 Remove all installed DIMMs.
2 Reinstall the DIMMs one by one to identify the
defective module.
3 Replace the defective DIMM with a new one.
0250 System battery is dead - Replace and
run SETUP The CMOS clock battery indicator shows the
system battery is dead.
1 Replace the system battery following the procedures
on page 59.
2 Run Setup to reconfigure the system.
0251 System CMOS checksum bad -
Default configuration used
The settings in the Setup Utility have been
corrupted or modified incorrectly, perhaps by an
application program that changes data stored in
CMOS.
Access Setup, and then either load the system
default values or enter your own custom values.
If the error persists, check the system battery or
contact your HP Customer Support provider.
0260 System timer error The timer test failed. Requires repair of the system
board.
0270 Real time clock error Real-Time Clock (RTC) fails BIOS hardware test.
May require board repair.