HP DL120 User Manual
Page 51
Removal and replacement procedures 51
3.
Rotate the load lever to the lock position.
To install the heat sink:
CAUTION: To prevent overheating or a possible system crash, use only a heat sink specified for
your ProLiant server.
1.
If you are using a new heat sink, remove the cover protecting the preapplied thermal compound.
Be careful not to touch or scratch the thermal compound.
2.
Install the heat sink.
a.
Insert the heat sink’s spring-loaded screws into the system board holes (1).
b.
Use the system screwdriver to tighten the spring-loaded screws (2).
3.
Reinstall the air baffle.
4.
Perform the post-installation procedure.