HP DL120 - Manual (Page 81)

Diagnostic tools 81
Exit menu
Field Description
Exit Saving Changes Saves changes made and closes the Setup Utility.
Keyboard shortcut: F10
Exit Discarding Changes Discards changes made and closes the Setup Utility.
Load Setup Default Loads the factory-default settings for all Setup fields.
Keyboard shortcut: F9
Discard Changes Discards all changes made to the Setup Utility and loads the previous
configuration settings.
Save Changes Saves all changes made to the Setup Utility.
Boot-time diagnostic screen
The boot-time diagnostic screen displays basic and important information about the current server
configuration and is necessary for troubleshooting and may be required when asking for technical
support. It is recommended that you check this screen during the initial system setup and each time
you install, remove, or upgrade accessories.
To view the boot-time diagnostic screen:
You first need to enable the display of the diagnostic screen during bootup. Follow the steps below.
1. In the Main menu screen, select Boot Features, and then press Enter.
2. Select the Boot-time Diagnostic Screen field.
3. Press the plus (+) or minus (–) key to set the field to Enabled.
4. Press F10 to save the changes you made and close the Setup Utility.