HP 300X - Manual (Page 17)

Installing 600N (EIO) Internal Print Servers 2-3
Internal Print
Servers
2
2. If Necessary, Set Switches or Jumpers on Your Card.
HP J3113A for Fast Ethernet (10/
100Base-TX) networks
Provides an RJ-45 connector (unshielded
twisted-pair cable). For 100Base-TX, use
Category 5 cable.
If You Have a Token Ring Card (J3112A)
Token Ring networks operate at 4 Mbps or
16 Mbps. You must set the Data Rate switch
on the card to either 4 or 16, depending on
your network. If you don’t know, ask your
network administrator. The factory default
setting is 16 Mbps.
If You Have a 10/100Base-TX Card
(J3113A)
The 10/100TX card is preconfigured for
Auto-negotiation (jumper P1), which means
the card will automatically attempt to
connect to your network using the proper
speed (10 or 100 Mbps) and duplex mode
(Full or Half).
In most cases, you do not need
to change the jumper settings. Refer to
“HP J3113A 10/100Base-TX Card” in this
chapter for more information.