Hitachi VT-UX605A - Manual (Page 28)

Getting Started (Initial Setup) - 28 -
add or delete channels. Use the number buttons to enter the channel you want to
change, then press STOP to delete it or press PLAY to add it.
Setting up Your VCR for Each Function Using the Menu Screen
Press GUIDE, then press 2 to bring up the VCR SETUP screen.
The screen shows the default settings on your VCR. The default settings are the ones
that are preset at the factory.
Look at each item to see if it matches your own setup:
To change a setting, press the button that has the same number as that item. This will
cycle you through several options.
When everything is set up as you want, press GUIDE again to back out of the VCR
SETUP screen.
Here is what the options mean:
1 AUTO BLUE
Press 1 to control the auto blue function which makes the screen blue and mutes sound
when you select a channel without a broadcast signal on the VCR or a channel on
which the broadcasting has finished. Options are and .
If the signal is too strong, this function may not operate even if you specify .
During playback this function does not operate.
4 HIFI/MIX/LINEAR
Press 4 to control how the audio signal is processed by the VCR. Options are ,
and .
5 STEREO/MONO
Press 5 to control how the audio signal is recorded and sent to the TV. Options are
and .
6 SAP
Press 6 when you are ready to ready to record a second audio program. Options are
and .
Choosing a Mode for Audio Playback
Choose between hi-fi and linear modes, depending on your needs.
HIFI is the preferred setting because it works for all tapes whether they were recorded
in hi-fi or linear modes. If the audio sounds distorted or unusual or there is no audio, try
the LINEAR option.
When you set the option to HIFI, hi-fi tapes will play in high fidelity, and non-hi-fi tapes
will play in linear mode.