Hitachi VT-UX605A - Manual (Page 13)

Getting Started - 13 -
3 Hook Up the Audio/Video Signal
If your TV is a fairly recent model, you probably have both audio and video jacks. Look
on the back of your TV for three jacks - possibly color-coded yellow, white, and red.
They will be labeled something like IN (L and R), AUDIO IN, or VIDEO IN. (If you are
not sure, look at the back of your VCR - you will see two sets of these jacks.)
If you have no jacks like these on your TV, skip this step and proceed to Step 4.
TV with Audio and Video Jacks
If you do find all three jacks on your TV, you need to purchase a three-line audio/video
cable with bell (RCA) connectors, like this:
If you find a video jack and only one audio jack, your TV is probably monaural. You can
purchase a two-line audio/video cable, but the three-line is handy in case you get a
stereo TV later.
Connect the yellow VIDEO OUT jack on the VCR to the VIDEO IN jack on the TV.
This direct video input will give you the best picture. It will also let you play videos in a
"picture in picture" feature, if your TV has it.
Then connect the AUDIO OUT jacks (red and white) on the VCR to the AUDIO IN
jacks on the TV (left to left, right to right).
This audio hookup will give you better sound than the RF signal hookup, because the
electronic signal won't have to go through a conversion process. Plus your VCR has a
stereo decoder, which your TV might not. For big speaker sound, you can also use
these jacks to connect the VCR to your stereo system (page 74).
Capabilities: The audio and video signal connections are all you need to play back a
prerecorded tape. If you do not intend to record on your VCR from your antenna/cable,
then you're all hooked up now. Otherwise, continue with Step 4, which will let you
record off TV channels.
4 Hook Up the RF Signal
Look at the back of your TV for a connector that looks like one of these, and follow the
corresponding hookup option. If you have any sort of cable box, see the hookup
options in Advanced Operations (page 71).