Hitachi VT-FX600A - Manual (Page 41)

TROUBLESHOOTING GUIDE - 41 -
JVC 100/ENT
Sharp 1 MEMORY
Sharp 2 SELECT
CONTROLLING THE TV
Once programmed, the VCR's remote control is ready to control the TV.
NOTE: Be aware that not all of your TV's functions may work even though the remote control is correctly
programmed.
1 Select the TV function mode
First press TV button to change to the TV function mode, then press the button of the TV function that you want.
For example;
Press TV button and the CH (
), and the TV station will change to the next higher station.
2 Return to the VCR function mode
Press VCR button to operate your VCR with the remote again.
REMOTE CONTROL OF THE CABLE CONVERTER
If you have a cable converter, you will probably want to program your VCR's remote control so you can easily
change channels. The process is the same as for programming the remote to operate your TV. For additional
details, see the previous page.
PROGRAMMING THE REMOTE CONTROL OF THE CABLE
CONVERTER
1 Program the remote control
Hold down the CATV button and press the number of your brand of cable box (shown in the chart).
NOTE: If that button combination does not work, or if your brand is not on the chart, just go through all the button
combinations until you find the one that works best.
Cable Converters Press CATV and This Number
Jerrold 1 1
Jerrold 2 2
Jerrold 3 3
Hamlin 4
Zenith 5
Scientific Atlanta 6
Pioneer 7
Philips 8
TO OPERATE THE CABLE BOX ONCE THE REMOTE IS
PROGRAMMED FOR IT.
1 Press CATV and then the button of the function you want.
2 Press VCR button to operate your VCR with the remote again.
TROUBLESHOOTING GUIDE
If you have followed the instructions contained in this manual and have difficulty in operating your VCR, locate the