Hitachi VT-FX600A - Manual (Page 11)

PREPARATION FOR USE - 11 -
SETTING A VIDEO CHANNEL
If your TV does not have A/V terminals;
When the VCR is in the Playback mode or when the VCR/TV button on the remote control is in the VCR position,
your TV will receive the signals from the VCR on either channel 3 or 4.
To use the VCR with your TV, set the selector switch to CH3 or CH4, whichever is not used or least used for
normal broadcasts in your area. Then set your TV to that same channel.
A/V TERMINALS
CONNECTING TO INPUT JACKS
INPUT SELECT
To use the external input jacks, select the AUX position. Press the CHANNEL or button or enter "00" with
number button on the remote control so that "AU" appears on the screen.
Note: "AU" is found before the lowest memorized channel. (Example: CH2)
INSTALLING THE BATTERIES
1) Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery compartment in the direction indicated by the polarity (+/-)
markings.
3) Replace the cover.