Hitachi VT-FX600A - Manual (Page 28)

SEARCH - 28 -
5 Begin Time Search
Press REW or F.FWD button. The VCR begins rewinding or fast forwarding to the specified point.
The time counts down as the searching progresses.
6 After Time Search
When 0:00 is reached, the VCR will start playback automatically.
NOTES:
• Time Search can be set up to 9 hours 59 minutes (9:59).
• This function will not operate in recording mode.
• Procedures must be followed within 30 seconds, from steps [3] to [4]. Otherwise the Time Search mode will be
cancelled.
• Press STOP button to exit the Time Search mode.
INDEX SEARCH
This feature provides a method of indexing the starting point so that it can be easily returned to in either fast
forward or rewind mode.
• The index mark will be made automatically when the REC button is pressed. It will also be marked at the starting
point of Timer recording and IRT.
• The index mark is not recorded if the PAUSE button is pressed and released during recording.
• The time gap between making the index marks on the tape should be greater than 1 minute for SP recording, 2
minutes for LP recording and 3 minutes for SLP recording.
Example: You are watching program number 4 and want to fast forward to program number 7. You must skip
three programs.
1 Select the main menu
Press MENU button.
2 Select "SEARCH SELECT"
Press CH or button repeatedly to point to "SEARCH SELECT".
Then, press SELECT button.
3 Select "INDEX SEARCH"
Press CH or button repeatedly to point to "INDEX SEARCH".
Then, press SELECT button.
4 Enter your desired number
Press CH or button repeatedly until the number of programs that you want to skip appears. (Example: "03"