Hitachi VT-FX600A - Manual (Page 17)

PRESET FOR USE - 17 -
TO RECALL A DESIRED CHANNEL
You can select the desired channel by using CHANNEL (or CH) or button or directly pressing number
buttons on the remote control.
Note for using number buttons:
• When selecting cable channels which are higher than 100, press 100/ENT button first, then press the last two
digits. (To select channel 125, first press "100/ENT" button then press "2" and "5").
• You must precede single-digit channel numbers with a zero (02, 03, 04 and so on).
TO DELETE PRESET CHANNEL
The channels you no longer receive or seldom watch can be deleted from the memory. (Of course, you can add
the deleted channel into the memory again.)
NOTE: You must use the remote control for this procedure.
Make sure...
• VCR power must be turned on.
• Turn on the TV and set the TV channel to the same video output channel as located on the back of the VCR.
(CH 3 or 4)
• Press VCR/TV button on the remote control so that "VCR" appears on the display.
1 Select the main menu
Press MENU button. The main menu appears on the TV screen.
2 Select "INITIALIZE"
Press CH or button repeatedly to point to "INITIALIZE".
Then, press SELECT button.
3 Select "CHANNEL SET UP"
Press CH or button repeatedly to point to "CHANNEL SET UP".
Then, press SELECT button.
4 Select "ADD/DELETE CH"
Press CH or button repeatedly to point to "ADD/DELETE CH".
Press SELECT button.