Hitachi VT-MX4430A - Manual (Page 34)

SPECIAL PLAYBACK
34
SPECIAL PLAYBACK
• Use the remote control for the following procedure.
• Be sure to check that the "PWR." and the "VCR" indicators are both on.
• Turn on the TV and set the TV channel to 3 or 4. Now set the CH3/CH4 switch on the back
of the VCR to match the channel selected on the TV.
.
AUTO REPEAT PLAYBACK
The VCR has the auto repeat function that allows you to repeat a tape indefinitely without
touching the PLAY button.
Make sure to insert a prerecorded tape.
1 Select "VCR SET UP"
Press MENU button until the VCR SET UP menu appears.
VCR SET UP
AUTO REPEAT
RENTAL
AUTO RETURN
2 Select "AUTO REPEAT"
Confirm "AUTO REPEAT" is pointed to.
3 Begin Auto repeat playback
Press the F.FWD/ button so that [ON] will appear next to "AUTO REPEAT" on the TV screen.
When in Stop mode, Repeat playback mode will start automatically.
· Once you select the Auto Repeat mode, it stays in effect even after you turn off the VCR.
· The COUNTER MEMORY does not function if the Auto Repeat mode is set to [ON]. In this
case, set the Auto Repeat mode to [OFF].
· To stop playback, press the STOP button.
TO EXIT THE AUTO REPEAT MODE
Repeat steps [1 ] to [2], Then, press the F.FWD/ button. [ON] will then disappear from the
menu. Press the RESET/EXIT button to return to TV mode