Hitachi VTUX-6450A - Manual (Page 34)

PRE-TUNING THE VCR TUNER - 34 -
CATV1: Ordinary cable
CATV2: Alternate cable (If CATV1 doesn't give you the channels you expect).
6 Press the (2) button.
CHANNEL PRESET
1 ANT 2 AUTO
CH SOURCE CHANNEL SET
3 CH LIST 4 VCR PLUS+
ADD/ERASE SETUP
5 CABLE BOX
SETUP END GUIDE
The VCR will automatically store channels received in your area. It takes about 2 - 3 minutes. After the channels
are stored in memory, the channel with the lowest number appears in the VCR's display.
7 Press GUIDE to return to regular viewing.
Note: Your VCR is capable of receiving 68 broadcast TV channels (VHF 2 – 13, UHF 14 – 69) and cable
channels (CATV 1 – 125). In some areas channels cannot be received when CATV1 is selected. In this case,
select CATV2 in the receiving setup.
When automatic presetting of channels are finished
Press the CH (channel) button (or numbered buttons) to check the channels you can receive.
Note: If no channels have been set or a clear picture does not appear, check the antenna or cable connection
To add or erase channels
The auto channel set procedure may memorize channels that are blank, have snowy pictures, or
interference. You may skip these channels by erasing them. Very weak stations might not be memorized
at all. You may receive these stations by adding them.
1 Press the GUIDE button.
The main on-screen menu will appear on the TV screen.
MENU
1 2 3
REVIEW SETUP CLOCK
4
CHANNEL
—————————————————
7 ENGLISH 8 FRANÇAIS
END GUIDE
2 Press the (4) button to select the CHANNEL PRESET operation.