HP Photosmart 7700 User Manual
Page 12
hp photosmart 7700 series
chapter 1
8
Your printer supports the following paper tray accessories that you can purchase
separately:
– Automatic Two-Sided Printing Accessory (HP C8955A) for double-sided
printing
– 250-sheet plain paper tray (HP Q3447A), which holds a half ream of
plain paper
load paper in the in tray
You can print using many different types of paper in the In tray, including plain
paper, HP photo paper, and HP premium inkjet transparency film. For more
information about supported paper types and sizes, see specifications on
page 53.
To load paper in the In tray:
1
Lift the paper catch.
2
Pull out the paper length guide on the In tray and slide the paper width
guide as far to the left as it will go.
3
Place a stack of paper in the In tray.
– Load the paper with the side to be printed facing down.
– Always load paper in the portrait orientation, with the shortest edge
toward you.
– Be careful not to use too much or too little paper. It may be difficult for
the printer to pick up a sheet of paper when there are only one or two
sheets in the In tray. Check that the stack of paper contains several
sheets, but is no higher than the top of the paper length guide. For
more information about the amount of paper to load in the In tray, see
specifications on page 53.
– Use one type and size of paper at a time. Do not mix paper types or
sizes in the In tray.