Humax F2-Green - Manual (Page 27)

Main Menu Guide
1. Select the L.O. Frequency that is set to antenna.
2. Press the button to display the LNB Frequency list box
(Item window).
3. Press the buttons to select the LNB frequency (Universal,
5150, 9750, 10600, 10750, 11475MHz, User Defined).
4. If the required LNB Frequency is not available then select
User Defined and press the OK button.
5. The Input text window will appear and you can enter the
frequency manually using the NUMERIC buttons(0~9).
6. When you select Universal, both 9750 and 10600MHz are
supported at the same time.
The 22KHz Tone setting is unnecessary. (Disabled)
When you use a dual LNB or two antennas connected to a
22KHz Tone switch box, make 22KHz Tone switch Enable or
Disable to select LNB or antenna.
According to the option and position of DiSEqC switch, select
Disabled, Tone Burst A to B and DiSEqC A to D.
After setting the above mentioned value, press the OK button
to move to the Manual Search menu.
The Motorised System is used to set the DiSEqC 1.2 motor by
Eutelsat specification.
If you wish to use this system, please refer to page GB39.
LNB Frequency
22KHz Tone
DiSEqC Input
Motorised System
GB26