HP SAS DL360 - Manual (Page 56)

56 HP ProLiant DL360 Generation 4p Server (SAS Model) User Guide
8. Install the expansion board into the slot until it seats firmly.
IMPORTANT: If the expansion board ships with an extender bracket,
remove it from the expansion board before inserting the board into the
expansion slot of the PCI riser board assembly.
IMPORTANT: Be sure that all DIMM slot latches are closed to provide
adequate clearance before installing the PCI riser board assembly with
a half-length expansion board.
9. Install the PCI riser board assembly.
IMPORTANT: The server will not power up if the PCI riser board
assembly is not seated properly.
NOTE: The same procedures apply for installing an expansion board in
PCI expansion slot 1.
Installing a PCI express riser board
NOTE: If the expansion slot is populated with the standard PCI-X
storage controller card, it should not be converted to PCI Express.
1. Power down the server ("Powering down the server" on page 24 ).
2. Extend the server from the rack, if applicable ("Extending the server from the
rack" on page 25 ).
3. Remove the access panel ("Removing the access panel" on page 26 ).
4. Remove the PCI riser board assembly ("Removing PCI riser board assembly"
on page 27 ).