Installing a sas or sata hot-plug hard drive, Installing a multi-bay device – HP SAS DL360 User Manual
Page 49

Hardware options installation
49
Installing a SAS or SATA hot-plug hard drive
1. Power down the server ("Powering down the server" on page
2. Remove the existing hard drive blank or hard drive from the drive bay
("Removing a hard drive blank" on page
3. Open the release latch to prepare the drive for installation.
4. Install the drive.
5. Determine the status of the drive by observing the drive LEDs ("Identifying
the status of a hard drive" on page
6. Resume normal server operations.
Installing a multi-bay device
1. Power down the server ("Powering down the server" on page
2. Push the multi-bay device ejector button and eject the device or blank.
This manual is related to the following products: