HP MP200 - Manual (Page 69)

64 65
En
gl
ish
En
gl
ish
naS function
The mp200 allows other devices on your network to access the USB storage device
plugged into the mp200.
enabling the naS function
Before enabling the NAS function, you need to configure the mp200’s networking
functions. Please refer to the network setup section of this guide for more details on
configuring the network.
The NAS feature is turned off by default and must be enabled in order to use it. To
enable this feature choose the “Setup” icon on the main menu, select the Network
category, and then set “NAS” to “On”.
While you are in the mp200’s Network page, you will see that the IP Address is
displayed (under the “Wired Lan setup” or the “Wireless Setup”. Please write down this
IP Address for accessing the NAS functionality later.
Accessing the NAS function
In order to access the mp200 media player, please make sure that you are using a
PC that is on the same network as the mp200. For example, using a Windows XP
PC, click “Start”, and navigate to “Run”. In the “Run” dialog, enter the command \\IP
Address (where IP Address is replaced with the address you wrote down in the previous
section). For example: