HP MP200 - Manual (Page 21)

16 17
En
gl
ish
En
gl
ish
Subtitle Color: This setting allows you to change the default color of the subtitle text.
The default color is white, but you can choose one of the following alternate colors:
red, yellow, green, blue and black.
Subtitle Delay: If you find that the video playback and the display of external subtitles
are not synchronized, you can increase or decrease the delay for the subtitle text. Use
the ◄ ► buttons on the remote control to choose a time from -2000 ms to 2000 ms.
Negative values will show the subtitle text earlier, while positive values will show the
subtitle text later.
6. Network
Select this option to access network settings for the mp200 media player.
Connection: You can use this setting to chose between the onboard (wired) Ethernet
to connect to your network. Only one interface can be enabled at a time. The use of a
wired Ethernet connection is recommended.
Wired LAN setup: The available options are: Cancel, DHCP IP (auto), Fixed IP
(manual), and PPPoE Setup. Select “Cancel” to discard your changes. Use “DHCP IP
(auto)” to have your router assign an IP address to the mp200 media player (this
assumes that your home network router is configured to use DHCP). Use “Fixed IP
(manual)” to setup the mp200’s IP Address manually.
Note: When using the Fixed IP (manual) setting, you must fill in the fields for: IP Address,
Subnet Mask, Default Gateway and DNS server IP Address.
NAS: Turn this function “On” to enable the mp200’s network attached storage function.
When this function is enabled, the USB storage devices inserted into the mp200 can be
accessed by other network clients on your network. Please refer to the section titled
“NAS function” for more details.
MAC Address: The MAC Address of the mp200 is displayed.