HP MP200 - Manual (Page 12)

8 9
RED / GREEN / YELLOW / BLUE: Special function
Function key Video playback DVD Menu File browser Network function
Red Open DVD Menu None Refresh
Green Toggle audio track Options Options
Yellow Switch the subtitle Switch to Thumbnail None
Blue Change the Angle Back to home Back to home
Connect
There are three ways shown below to connect this player to your TV set. Please choose
the one that best applies to your TV/Stereo configuration.
Basic connection (standard definition):
Power Cord: Connect the DC power adapter to the mp200 media player.
Audio cable output: Using the supplied analog stereo cable, connect the mp200 audio
output to your TV set.
CVBS video output (NTSC or PAL): Using the supplied composite video cable, connect the
mp200 video output to your TV set.
Advanced connection (high definition):
Power Cord: Connect the DC power adapter to the mp200 media player.
Audio cable output: Connect the cables to TV set.
Component video cable for HD video output (720p, 1080i): Connect the 1/8” jack of the
AV (component) cable to the back of the mp200, and then connect the other end of the
component cable to the YPbPr input of your TV set.
HDMI connection (high definition):
Power Cord: Connect the DC power adapter to the mp200 media player.
HDMI output to TV (Up to 1080p): Using the supplied HDMI cable, connect one end to the
back of the mp200 and the other end to your TV set. Note that the HDMI port sends digital
video and audio signals through the same cable. In this configuration, the audio output
must be set to LPCM 2CH. Please refer to the audio section of the user’s manual for more
information.
*HDMI output to HDMI receiver: Using the supplied HDMI cable, connect one end to
the back of the mp200 and the other end to your HDMI receiver, in this configuration,
the multichannel audio can be enabled and decoded by the HDMI receiver. Please