HP COMPAQ DX2718 MT - Manual (Page 90)

D–10 483941-001 Service Reference Guide
Troubleshooting Without Diagnostics
Solving Audio Problems
Solving Audio Problems
Problem Cause Solution
Sound does not come
out of the speaker or
headphones. Software volume control
is turned down. Double-click the Speaker icon on
the taskbar and use the volume
slider to adjust the volume.
The external speakers
are not turned on. Turn on the external speakers.
External speakers
plugged into the wrong
audio jack. See the sound card documentation
for proper speaker connection.
Audio cable not
connected. Connect audio cable between CD
or DVD-ROM drive and the system
board.
Digital CD audio is not
enabled. Enable digital CD audio:
1. From the Control Panel, select
System.
2. On the Hardware tab, click
the Device Manager button.
3. Right-click on the CD/DVD
device and select Properties.
4. On the Properties tab, make
sure “Enable digital CD
audio for this CD-ROM
device” is checked.
Headphones or devices
connected to the line-
out connector mute the
internal speaker. Turn on and use headphones or
external speakers, if connected, or
disconnect headphones or external
speakers.
Volume is muted. 1. From the Control Panel
program, click Sound,
Speech and Audio
Devices, then click Sounds
and Audio Devices.
2. Click the Mute check box to
remove the check mark from
the box.
Computer is in
standby mode. Press the power button to resume
from standby mode.
Ä CAUTION: When attempting to resume from standby mode, do not hold down the
power button for more than four seconds. Otherwise, the computer will shut down and
you will lose your data.