HP AMS DL320 - Manual (Page 15)

Server operations 15
Server operations
In this section
Powering up the server ........................................................................................................................... 15
Powering down the server ....................................................................................................................... 15
Preparation procedures........................................................................................................................... 16
Extending the server from the rack............................................................................................................ 16
Removing the server from the rack............................................................................................................ 16
Removing the access panel...................................................................................................................... 17
Installing the access panel ....................................................................................................................... 17
Removing the PCI riser board assembly .................................................................................................... 17
Installing the PCI riser board assembly...................................................................................................... 18
Removing the fan assembly ..................................................................................................................... 18
Installing the fan assembly....................................................................................................................... 20
Powering up the server
To power up the server, press the Power On/Standby button.
Powering down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1. Back up the server data.
2. Shut down the operating system as directed by the operating system documentation.
NOTE: If the operating system automatically places the server in Standby mode, omit the next step.
3. Press the Power On/Standby button to place the server in standby mode. When the server activates
standby power mode, the system power LED changes to amber.
IMPORTANT: Pressing the UID button illuminates the blue UID LEDs on the front or rear panels. In a rack
environment, this feature facilitates locating a server when moving between the front and rear of the rack.
4. Disconnect the power cords.
The system is now without power.