Honeywell HRDE4X4 - Manual (Page 32)

Rev 3.01 22 Document 900.0399
08/08
forwarding so that each port, when accessed on the IP sharing device, will forward to the
appropriate DVR.
Note This port number is listed next to the PORT menu option in the Network
Setup screen. If you plan to access the DVR units only from within the same
LAN, the RTSP port does not have to be changed.
Network Types
There are three network types available. Each type requires different settings.
LAN
To use the LAN option when connecting the DVR to a network, the following information is
required. See your network administrator if you do not have this information.
IP The fixed IP address of the DVR unit
Subnet Mask The Subnet Mask for the LAN
Gateway The IP address of the Gateway
DNS Server IP The IP address for the DNS server
DHCP
Select DHCP to use the DHCP option when connecting the DVR to a network. The DHCP
server automatically assigns an IP address, and then automatically assigns IP addresses
and other parameters to new devices. The assigned IP address and MAC address are
displayed when DHCP is selected.
If the network connection does not allow additional IP addresses, then an IP sharing device
is needed. In this case, forwarding may be needed to allow for a network connection. For
more information on port forwarding, see the documentation for your IP sharing device, or
contact your network administrator.
ADSL
To use the ADSL option when connecting the DVR to a network, the following information is
required. See your network administrator if you do not have this information.
ID The user ID for the ADSL connection
Password The password for the ADSL connection
Your ADSL connection must have an RJ45 output to connect to the DVR.
When sharing the connection with other devices, an IP sharing device should be used. In
this case, select LAN as the NETWORK TYPE. You must also configure the IP sharing
device for port forwarding to allow for a network connection.
For more information on port forwarding, see the documentation for your IP sharing device
or contact your network administrator.