HP DL385 - Manual (Page 59)

Hardware options installation 59
WARNING: To reduce the risk of personal injury from hot surfaces, allow the power
supply or power supply blank to cool before touching it.
3. Slide the power supply into the power supply bay.
4. Connect the power cord to the power supply.
5. Route the power cord through the cable management arm or power cord anchor.
NOTE: If using the power cord anchor, be sure to leave enough slack in the power cord so that the
redundant power supply can be removed without disconnecting the power cord from the primary power
supply.
6. Reposition the cable management arm into the operating position.
7. Connect the power cord to the power source.
8. Be sure that the power supply LED is green.
9. Be sure that the front panel external health LED is green (" Front panel LEDs and buttons " on page 9 ).
Expansion board options
NOTE: This procedure shows images of the SCSI model server, but it also applies to the SAS model server.
The server supports PCI and PCI-X expansion boards.
For instructions on installing a RILOE II board, refer to the HP Remote Insight Lights-Out Edition II User
Guide on the Documentation CD.
IMPORTANT: The optional RILOE II board can be installed only in slot 3. If you plan to install a RILOE II
board in the future, leave slot 3 unpopulated.
1. Power down the server (on page 27 ).
2. Extend or remove the server from the rack (" Extend the server from the rack " on page 28 ).
3. Remove the access panel (" Removing the access panel " on page 29 ).