HP DL385 - Manual (Page 29)

Server operations 29
3. After performing the installation or maintenance procedure, slide the server back into the rack:
a. Press the server rail-release latches and slide the server fully into rack.
b. Press the server firmly into the rack to secure it in place.
Removing the access panel
WARNING: To reduce the risk of personal injury from hot surfaces, allow the drives and
the internal system components to cool before touching them.
CAUTION: Do not operate the server for long periods with the access panel open or removed. Operating
the server in this manner results in improper airflow and improper cooling that can lead to thermal damage.
1. Power down the server if performing a non-hot-plug installation or maintenance procedure (" Power
down the server " on page 27 ).
2. Extend the server from the rack, if applicable (" Extend the server from the rack " on page 28 ).
3. Lift up on the hood latch handle and remove the access panel.
Installing the access panel
1. Place the access panel on top of the server with the hood latch open. Allow the panel to extend past
the rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the hood latch. The access panel slides to a closed position.