Server operations, Power up the server, Power down the server – HP DL385 User Manual
Page 27
Server operations 27
Server operations
In this section
Power up the server................................................................................................................................ 27
Power down the server............................................................................................................................ 27
Extend the server from the rack ................................................................................................................ 28
Removing the access panel...................................................................................................................... 29
Installing the access panel ....................................................................................................................... 29
Access the product rear panel.................................................................................................................. 30
Removing the PCI riser cage .................................................................................................................... 31
Installing the PCI riser cage ..................................................................................................................... 31
Front fan bracket.................................................................................................................................... 32
Power up the server
To power up the server, press the Power On/Standby button.
Power down the server
WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
1.
Back up the server data.
2.
Shut down the operating system as directed by the operating system documentation.
3.
If the server is installed in a rack, press the UID LED button on the front panel (1). Blue LEDs
illuminate on the front and rear panels of the server.