Humminbird 1197C SI - Manual (Page 22)

5. Insert the control head through the mounting hole from the front side of the dash. Place a lock
washer onto each threaded rod, then secure the bracket: place a wing nut onto each threaded
rod and tighten fully.
6. Thread the cables through the opening in the back of the cable collector cover.
7. Insert cable connectors into the proper recesses on the cable collector insert. The cable
connectors are keyed to prevent reverse installation, so be careful not to force the connectors into
the wrong slots. If you don’t have a cable for every hole in the insert, install the blank plugs to
protect the control head from the weather.
8. Line up the cable collector insert and cover, with the keying feature, then slide the cover into
place on the insert.
Transducer
Cable Collector Cover
4
5
Cable Collector Insert 6
Inserting the Cables into the Cable Connector Insert
1 2
3 4 Power
Communications
1
2
Temp/Speed 3
5
6
Threaded Rod 1
Washer 2
Wing Nut 3
Lock Washer 4
Cut Away Dash 5
Foam Pads 6
1 2
3
5
4
6
6
6
14
531617-1_A - 1197c_ManE.qxp 11/6/2007 4:36 AM Page 14