Humminbird 1197C SI - Manual (Page 19)

7. Place the mounting bracket on the mounting surface aligned with the drilled holes and fill the
mounting holes with marine grade silicone sealant. Insert the four #10 Slotted-Hex wood screws
into the mounting holes. Hand-tighten only.
8. If the cable pass through hole is beneath the mounting bracket, you will need to install the hole
cover after you have routed all cables. Place the hole cover over the mounting bracket cable pass
thru hole and align with holes drilled in step 6a. Insert the #8 Phillips countersink wood screws.
Hand tighten only.
NOTE: Be sure that the cables pass through the slots on the hole cover and that there is enough cable slack to
allow for the control head to pivot through its full tilt range. Extra cable slack will also help when connecting or
disconnecting the cables.
9. Thread the cables through the opening in the back of the cable collector cover.
Gimbal Mounting Bracket 1
Grommet 2
Hole Cover 3
1
2
Cables Routed Behind Mounting Bracket
3
Gimbal Mounting Bracket 1
Hole Cover 2
1
2
Cables Routed Directly Beneath Mounting Bracket
11
531617-1_A - 1197c_ManE.qxp 11/6/2007 4:36 AM Page 11