HP xw8000 - Manual (Page 34)

QuickSpecs
HP Workstation xw8000
DA-11506 North America — Version 11 — June 2, 2003 34
Technical Specifications
16X/40 DVD-ROM Read Height 5.25-inch, half-height
Interface type ATAPI
Dimensions– External,
Excluding Bezel (W x H)
5.88 x 1.71 in/14.94 x 4.34 cm
Disc diameter 5 in, 3 in (12 cm, 8 cm)
Disc thickness 0.05 inch (1.2 mm)
Track pitch 1.6 µm (CD), 0.74 µm (DVD)
Disc center hole diameter 0.6 inch (15 mm)
Disc formats DVD-ROM (single and dual layer); DVD-video; DVD-R version 1.0 and 2.0; DVD-
RW version 1.0 and 1.1; DVD-R/RW multi-border; DVD+RW; CD-ROM Mode 1
and 2; CD-DA; CD-ROM XA Mode 2, Form 1 and 2; CD-extra; CD-text; CD-I
Mode 2, Form 1 and 2; CD-I ready; video CD, CD-bridge; PhotoCD (single and
multi-session); CD-R; CD-RW
DVD-ROM
4.7 GB (DVD-5), 8.54 GB (DVD-9), 9.4 GB
(DVD-10), 3.95 GB (DVD-R version 1.0), 4.7
GB (DVD-R version 2.0), 4.7 GB (DVD-RW
version 1.0 and 1.1), 4.7 GB (DVD
+ RW)
Disc capacity
CD-ROM 540 MB (Mode 1, 12 cm), 640 MB (Mode 2, 12
cm), 700 MB (80 minimum CD-R and CD-RW),
180 MB (8 cm)
Block size (bytes) DVD-ROM – 2048; CD-ROM Mode 0 – 2352; CD-ROM Mode 1 – 2352, 2340,
2336, 2048; CD-ROM Mode 2 – 2352, 2340, 2336, 2048
DVD-ROM single layer < 120 ms Access times (typical reads,
including settling)
CD-ROM Mode 1 < 90 ms
Full stroke DVD < 240 ms (seek)
Full stroke CD < 160 ms (seek)
Data transfer rates 2600 – 6000 KB/s (40X CAV CD-ROM mode)
8100 – 21,600 KB/s (16X CAV DVD-ROM mode)
Data transfer modes PIO Mode 4 (16.6 MB/s); Multi-word DMA mode 2 (16.6 MB/s); UltraDMA Mode 3
(44.4 MB/s)
Power Source Four-pin, DC power receptacle
5 VDC ± 5%—100 mV ripple p-p DC power requirement
12 VDC ± 5%—200 mV ripple p-p
DC current 5 VDC − <800 mA typical,
< 1000 mA maximum
12 VDC − < 870 mA typical
Audio Output Level 0.7 Vrms (typical)
Configuration Jumper Block Master, slave, and cable select modes
Data interface connector
40-pin, shrouded and keyed, flat ribbon
Temperature (operating) 41 ° to 122 ° F/5 ° to 50 ° C
Relative humidity (operating) 10% to 85%
Environmental (all conditions
non-condensing)
Maximum wet bulb
temperature (operating) 86 ° F/30 ° C
Certifications, approvals MMC II support, multi-read certification, Microsoft WHQL certification, ACA
AS/NZS 3548 class B, CNS 13438, C.I.S.P.R. Pub 22, TUV or VDE EN60950,
EN 55022, EN55024, SEMKO, NEMKO, DEMKO, FIMKO, EN 60825-1, UL
60950, CSA C22.2 60950-2000,
Operating systems supported Microsoft Windows 98, Microsoft Windows NT 4.0, Microsoft Windows 2000,
Windows XP Professional