Epson 62c/82c - Manual (Page 87)

Solving Problems 87
■ Depending on your computer’s video card, you might need to use
the Display utility in the Control Panel to make sure that both the
LCD screen and external monitor port are enabled. See your
computer’s documentation or online help for details.
If you’re using a PowerBook or iBook with
Macintosh OS X:
1. From the Apple menu, select System Preferences , then click
Display or Displays .
2. Select VGA Display or Color LCD , click Arrange or
Arrangement , then put a check mark in Mirror Displays .
If you’re using a PowerBook or iBook with
Macintosh OS 9:
1. From the Apple menu, select Control Panels , then click
Monitors or Monitors and Sound.
2. Click the Arrange icon.
3. Drag one monitor icon on top of the other. This lets you display
on the projector screen as well as the LCD screen.
4. If the Arrange icon isn’t available, click the Monitor icon.
5. Select one of the listed Simulscan resolutions. (Allow a few
seconds for the projector to sync up after making the selection.)
The message Not Supported is displayed.
■ Make sure your computer’s resolution doesn’t exceed XGA (for
the PowerLite 82c) or SVGA (for the PowerLite 62c) and the
frequency is supported by the projector. See page 100. If
necessary, change your computer’s resolution setting as described
below.
■ Make sure the correct Video Signal is selected in the Signal
menu. See page 60. It should normally be set to Auto .