Epson 62c/82c - Manual (Page 79)

Maintaining and Transporting the Projector 79
9. Lower the lamp cover into place. (The opening should be almost
covered, and the top of the cover should be flush with the top of
the projector.) Then slide the cover closed and tighten the screw.
10. Reset the lamp timer as described in the next section.
Resetting the Lamp Timer
You must reset the lamp timer after replacing the lamp to clear the
Replace the Lamp warning message. Follow these steps:
1. Connect the power cable and turn on the projector.
2. Press the Menu button on the remote control or projector and
select the Reset menu. Then press Enter . You see the following:
3. Select the Lamp-Hours Reset option and press Enter . You see
the following:
note
Do not reset the lamp timer if
you have not replaced the
lamp. If you do, the Lamp
Hours will not accurately
reflect the number of hours
that the lamp has been used.
Enter button Menu button
Esc button