Samsung 30 Inch Smart Slide-In Induction Range Owners Guide - Manual (Page 64)

64 English
Tr
ouble
shoo
ting
Troubleshooting
COOKTOP
Displayed code Possible cause Solution
F0
This code occurs if communication
between the Main and Inverter PBA
is interrupted.
Power Off, and then
Power On to the setting
you want again. If
the problem persists,
disconnect all power to
the range for at least
30 seconds and then
reconnect the power.
If this does not solve
the problem, call for
service.
C0
The top sensor is open when the
burner is operating.
Call for service
The top sensor is short when the
burner is operating.
C2
The IGBT sensor is open when the
burner is operating.
The IGBT sensor is short when the
burner is operating.
A2
This code occurs if the DC fan motor
is open or locked.
Displayed
code
Possible cause Solution
C-22
The sub PCB sensor is open
when the oven is operating.
Tap Stop , and then restart the
oven. If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
There is a short in the sub PCB
sensor.
C-30
The main PCB sensor is open
when the oven is operating.
There is a short in the main PCB
sensor.
C-31
This code occurs if the PCB
temperature rises abnormally
high.
Call for service
Bad line
This error message appears
if the power cord is installed
improperly.
If the power connection is
plugged in improperly, that
code appears on the display.
Reconnect the power
connection properly, and the
message disappears.
C-A2
This code occurs if the sub PCB
temperature rises abnormanlly
high.
Tap Stop .
Check the oven vent and
cooling vent. If the vent is
closed, never block the vent
by anything. After cooling the
oven, restart the oven.
If this does not solve the
problem, call for service.