Getting started with your appliance – Hestan 30 Inch Freestanding Professional Gas Range Use and Care Manual User Manual

Page 16

GETTING STARTED WITH YOUR APPLIANCE

(CONTINUED)

SEALED BURNERS

Ensure the sealed burner heads are properly installed and seated on the burner base as shown below.

There are notches on the burner base and cross ring to help with alignment. The outer burner head

features a long slot on the top of the head which aligns with the spark igniter. Assembly of the

single-flow burner head is similar.

FIRST TIME OPERATION

Ensure there are no packaging materials inside the oven. Remove any labels or plastic film from the

outside of the appliance. Before using your oven for the first time, it will be necessary to run a bake

cycle to burn off any manufacturing oils and residues from the oven cavity. This may produce a little

smoke and some odor. This is normal and is typical of any new oven when first used. If the smell

is strong, remove persons and animals from the kitchen during this period. Open any windows to

further vent the odor from the room.
Install all the oven racks. Turn on your vent hood, and run the oven on BAKE at 500°F [260°C] for

1-1/2 hours. Allow to cool completely before attempting to cook.

DUAL FLOW

BURNER

SINGLE FLOW

BURNER

RING

BURNER

HEAD

BURNER

BASE

IGNITER

INNER

BURNER

HEAD

OUTER

BURNER

HEAD

BEAUTY

RING

CROSS

RING

BURNER

BASE

This manual is related to the following products: